PM 719T Hollow Chisel Mortiser Review

PM 719T Hollow Chisel Mortiser Review

    Problem. I prefer the mortise and tenon joint. Most of my projects join ¾” thick stock. I am not one to create a mortise by chopping with a chisel, drilling a series of holes that are then squared up, or setting up the router – I am just not patient...
Freud P410 Fusion Full Kerf

Freud P410 Fusion Full Kerf

    I received this from my wife for Christmas. (Good wife huh?)It was ordered from Amazon.com and came via OnTrac in great condition.So far I am very pleased with the performance.I have crosscut and ripped several feet of Maple & Birch and I have no...
DON’T BUY THIS

DON’T BUY THIS

    DON’T BUY THIS PRODUCT. So bad that I think Arrow took it off the market. Will definitely NOT drive any length nail into pine (e.g. house trim) and certainly not into hardwoods (oak, etc.) Tried 2 of them… same result. Guy at Lowes says they...
LED T8 replacement shop lighting

LED T8 replacement shop lighting

    I just finished replacing all my shop T8 bulbs with these which are directly replaceable for modern T8 ballasts. However, they also work without a ballast directly from 110V or 220V. I started by simply removing the old T8’s and replacing them with...
A great dado set..

A great dado set..

    Since I purchased my rigid tablesaw I have been really trying to advance my knowledge of exactly what a TS can do and I figured joinery techniques was a good a place as any.. In in the middle of the design phase of creating mitre saw station and I think...
All Star Performer

All Star Performer

    This is a review of the LU86 thin kerf 40 tooth general purpose blade. I have been using this blade for all rips and crosscuts, and I must say I’m quite impressed. For ripping I was mentally comparing it to my Freud 24 tooth dedicated ripping...
Page 3 of 3612345...102030...Last »